深圳市金霖电子商行（原深圳市鸿成电子） （非本站正式会员）

特点
以下是功能的MC92600：
•四个全双工的差分数据链接。
•每个收发器可以运行在1.25 Gbaud的0.625 Gbaud的。
•低功耗约800mW的典型条件下，同时经营所有收发器在全速运转。
•内部8B/10B编码器/解码器的访问是通过字节接口或绕过10位接口模式。
•单，双数据速率接口。
•接收到的数据可被恢复的时钟或参考时钟相一致。
•驱动50或75欧姆媒体（100或150欧姆差分），长度可达1.5米板/背板，或10米的同轴电缆。Features
The following are the features of the MC92600:
• Four full-duplex differential data links.
• Each transceiver can operate at 1.25 Gbaud or 0.625 Gbaud.
• Low power, approximately 800mW under typical conditions, while operating all transceivers at full speed.
• Internal 8B/10B encoder/decoder is accessed through the byte interface or is bypassed in 10-bit interface mode.
• Single and double data rate interfaces.
• Received data may be aligned to the recovered clock or to the reference clock.
• Drives 50 or 75 ohm media (100 or 150 ohm differential) for lengths of up to 1.5 meters board/backplane, or 10 meters of coax.

•链路链路同步支持对齐字传输。可承受+40链接链接媒体位时间延迟歪斜。
•可选的发射器/接收的字节对齐模式，使非对齐传输或具有自动调整对齐的传送。
•中继模式配置成4连杆接收传输中继器MC92600。
•可承受在超过+250 ppm频率偏移。
•在芯片接收链路终止。
•接收机的链接输入“热插拔”兼容。
•片上50欧姆的串联源终止的TTL并行输出。
•内置自我测试，生产测试和车载诊断系统。

Block Diagram
• Link-to-link synchronization supports aligned word transfers. Tolerates +40
bit-times of link-to-link media delay skew.
• Selectable transmitter/receiver byte alignment modes enable unaligned transfers or
aligned transfers with automatic realignment.
• Repeater mode configures the MC92600 into a 4-link receive-transmit repeater.
• Tolerates frequency offset in excess of +250ppm.
• On-chip receiver link termination.
• Receiver link inputs “hot swap” compatible.
• On-chip 50 ohm series source termination of TTL parallel outputs.
• Built-in self test for production test and on-board diagnostics.

MC92600是一款高度集成的器件包含一个高速串行接口，方便应用和测试所需的所有的逻辑。无需外部元件，以及其他比正常的电源去耦网络是必需的。

The MC92600 is a highly integrated device containing all of the logic needed to facilitate the application and test of a high-speed serial interface. No external components, other than the normal power supply decoupling network are required.